Displaying The State And Information Of The System; System Debugging; Enable/Disable The Terminal Debugging - 3Com Switch 4500 26-Port Configuration Manual

250 C 15: S
HAPTER YSTEM
Displaying the State
and Information of
the System

System Debugging

Enable/Disable the
Terminal Debugging
M D
AINTENANCE AND EBUGGING
The commands can be classified as follows according to their functions.
display
Commands for displaying the system configuration information
■
Commands for displaying the system running state
■
Commands for displaying the system statistics information
■
For the commands related to each protocol and different ports, refer to
display
the relevant chapters. The following
the system state and the statistics information.
Configuration agent is one of the XRN features. You can log into one Switch of
the Fabric to configure and manage the Fabric. The functions of the configuration
agent include:
Distributing configuration commands to the right destination Switches or
■
processing modules based on the resolution result of the commands input.
Sending output information of the commands from the Switch you have
■
logged into to your terminal.
Supporting simultaneous configuration of multiple users.
■
You cannot configure the configuration agent, but can view the statistics of the
configuration agent.
Perform the following operations in all views.
Table 272 The Display Commands of the System
Operation
Display the system clock
Display the system version
Display the saved-configuration
Display the current-configuration display current-configuration [
Display the state of the
debugging
Display statistics of the
configuration agent
The Switch provides various ways for debugging most of the supported protocols
and functions, which can help you diagnose and address the errors.
The following Switches can control the outputs of the debugging information:
Protocol debugging Switch controls the debugging output of a protocol.
■
Terminal debugging Switch controls the debugging output on a specified user
■
screen.
commands are used for displaying
display
Command
display clock
display version
display saved-configuration
controller | interface interface-type [
interface-number ] | configuration [
configuration ] ] [ | { begin | exclude |
include } regular-expression ]
display debugging [ interface {
interface-name | interface-type
interface-number } ] [ module-name ]
display config-agent unit-id unit-id