Displaying Radio Profile Information; Displaying Map Status Information - 3Com WX1200 3CRWX120695A Configuration Manual

260 C 10: C
HAPTER ONFIGURING
Displaying Radio
Profile Information
WX# display radio-profile default
Beacon Interval:
Max Tx Lifetime:
RTS Threshold:
Long Preamble:
Tune Channel Range (11a):
Tune Power:
Tune Power Interval:
Channel Holddown:
Active-Scan:
WMM Powersave:
Rate Enforcement:
ETT Link Factor:
Dwell Time:
Intial Measur Interval:
Radio Link Timeout:
Displaying MAP
Status Information
MAP A P
CCESS OINTS
(For information about the fields in the output, see the
Switch and Controller Command
To display radio profile information, use the following command:
display radio-profile {name | ?}
Entering display radio-profile ? displays a list of radio profiles.
To display radio profile information for the default radio profile, type the
following command:
100
2000
2346
lower-bands
600
300
yes
3600
(For information about the fields in the output, see the
Switch and Controller Command
To display status information including link state and WX status, use the
following commands:
display ap status [terse] | [apnumber | all [radio {1 | 2}]]
The terse option displays a brief line of essential status information for
each directly connected MAP or Distributed MAP.
The all option displays information for all directly attached MAPs and all
Distributed MAPs configured on the switch.
Reference.)
DTIM Interval:
Max Rx Lifetime:
Frag Threshold:
no Tune Channel:
Ignore Clients:
no Tune Channel Interval:
Power ramp interval:
Countermeasures:
RFID enabled:
no QoS Mode:
no Initial Load:
3 Change Threshold:
Probe Interval:
60 Maximum Measure Interval:
5
Reference.)
Wireless LAN
1
2000
2346
yes
no
3600
60
none
no
wmm
1000
25
60
600
Wireless LAN