Displaying Connection Information For Distributed Maps - 3Com WX1200 3CRWX120695A Configuration Manual

Displaying
Connection
Information for
Distributed MAPs
force-rebalance: NO,
Radio 2: type: 802.11a, mode: disabled, channel: dynamic
tx pwr: 17, profile: default
auto-tune max-power: default,
load-balance-group: ,
load-balance-enable: YES,
force-rebalance: NO,
local-switching: enabled, vlan-profile: locals
(For information about the fields in the output, see the
Switch and Controller Command
To display connection information for Distributed MAPs configured on a
WX switch, use the following command:
display ap global [apnumber | serial-id serial-ID]
This command lists the System IP addresses of all the WX switches on
which each Distributed MAP is configured, and lists the bias for the MAP
on each switch. For each Distributed MAP that is configured on the
switch on which you use the command, the connection number is also
listed.
Connections are shown only for the Distributed MAPs that are configured
on the WX from which you enter the command, and only for the Mobility
Domain the WX is in.
To display connection information for all Distributed MAPs configured on
a WX switch, type the following command:
WX4400# display ap global
Total number of entries: 8
AP Serial Id
--- -----------
1 M9DE48B012F00 10.3.8.111
- M9DE48B012F00 10.4.3.2
2 M9DE48B123400 10.3.8.111
- M9DE48B123400 10.4.3.2
17 M9DE48B123600 10.3.8.111
- M9DE48B123600 10.4.3.2
18 M9DE48B123700 10.3.8.111
- M9DE48B123700 10.4.3.2
Reference.)
WX IP Address Bias
--------------- ----
HIGH
LOW
LOW
HIGH
HIGH
LOW
LOW
HIGH
Displaying MAP Information
Wireless LAN
257