Adding Or Removing A Static Multicast Router Port; Adding Or Removing A Static Multicast Receiver Port; Displaying Multicast Information; Displaying Multicast Configuration Information And Statistics - 3Com WX1200 3CRWX120695A Configuration Manual

Adding or Removing
a Static Multicast
Router Port
Adding or Removing
a Static Multicast
Receiver Port
Displaying
Multicast
Information
Displaying Multicast
Configuration
Information and
Statistics
WX1200# display igmp vlan orange
VLAN: orange
IGMP is enabled
Proxy reporting is on
Mrouter solicitation is on
Querier functionality is off
Configuration values: qi: 125 oqi: 300 qri: 100 lmqi: 10 rvalue: 2 Multicast
router information:
Port Mrouter-IPaddr Mrouter-MAC
---- --------------- ----------------- ----- -----
1 192.28.7.5 00:01:02:03:04:05 dvmrp
Group
--------------- ---- --------------- ----------------- -----
224.0.0.2 none none
237.255.255.255
To add or remove a static multicast router port, use the following
command:
set igmp mrouter port port-list {enable | disable}
To add a static multicast receiver port, use the following command:
set igmp receiver port port-list {enable | disable}
You can use the CLI to display the following IGMP snooping information:
Multicast configuration information and statistics
Multicast queriers
Multicast routers
Multicast receivers
To display multicast configuration information and statistics, use the
following command:
display igmp [vlan vlan-id]
The display igmp command displays the IGMP snooping state, the
settings of all multicast parameters you can configure, and multicast
statistics.
To display multicast information for VLAN orange, type the following
command:
Port Receiver-IP
5 10.10.10.11 00:02:04:06:08:0b

Displaying Multicast Information

Type TTL
17
Receiver-MAC
none
TTL
undef
258
373