3Com WX1200 3CRWX120695A Configuration Manual page 101

===============================================================================
Boot Time:
Uptime:
===============================================================================
Fan status: fan1 OK fan2 OK fan3 OK
Temperature: temp1 ok
PSU Status: Lower Power Supply DC ok AC ok
Memory: 156.08/496.04 (31%)
Total Power Over Ethernet : 0.000
===============================================================================
WX1200# set port type ap 2-4 model ap2750 poe enable
This may affect the power applied on the configured ports.
Would you like to continue? (y/n) [n]y
success: change accepted.
WX1200# display port status
Port Name
===============================================================================
1 mgmt
2 finance
3 accounting
4 shipping
5 lobby
6 lobby
7 conf_room1
8 conf_room1
WX1200# display port poe
Port Name
===============================================================================
1 mgmt
2 finance
3 accounting
4 shipping
5 lobby
6 lobby
2000-03-18 22:59:19
0 days 00:13:45
temp2 ok
3 Configure ports 2 through 4 for connection to MAP model AP2750 and
verify the configuration changes. Type the following commands:
Admin Oper
up up
up up
up up
up up
up up
up up
up up
up up
Link Port
Status Type
up -
up MAP
up MAP
up MAP
up -
up -
Port and VLAN Configuration Scenario
temp3 ok
Upper Power Supply missing
Config Actual
auto 100/full
auto 100/full
auto 100/full
auto 100/full
auto 100/full
auto 100/full
auto 100/full
auto 100/full
PoE PoE
config Draw(Watts)
disabled off
enabled 7.11
enabled 7.11
enabled 7.11
disabled off
disabled off
Type Media
network 10/100BaseTx
ap 10/100BaseTx
ap 10/100BaseTx
ap 10/100BaseTx
network 10/100BaseTx
network 10/100BaseTx
network 10/100BaseTx
network 10/100BaseTx
101