3Com WX1200 3CRWX120695A Configuration Manual page 210

210 C 10: C
HAPTER ONFIGURING
MAP A P
CCESS OINTS
Table 12 Defaults for Radio Profile Parameters (continued)
Parameter Default Value
frag-threshold 2346
max-rx-lifetime 2000
max-tx-lifetime 2000
preamble-length short
qos-mode wmm
rfid-mode disable
rts-threshold 2346
service-profile No service
profiles defined
wmm-powersave disable
(To configure a radio profile, see "Configuring a Radio Profile" on page 240.)
Radio Behavior When Parameter Set to
Default Value
Uses the short-retry-count for frames shorter
than 2346 bytes and uses the
long-retry-count for frames that are 2346
bytes or longer.
Allows a received frame to stay in the buffer
for up to 2000 ms (2 seconds).
Allows a frame that is scheduled for
transmission to stay in the buffer for up to
2000 ms (2 seconds).
Advertises support for short 802.11b
preambles, accepts either short or long 802.11b
preambles, and generates unicast frames with
the preamble length specified by the client.
Note: This parameter applies only to
802.11b/g radios.
Classifies and marks traffic based on 802.1p
and DSCP, and optimizes forwarding
prioritization of MAP radios for Wi-Fi
Multimedia (WMM).
Radio does not function as a location
receiver in an AeroScout Visibility System.
Transmits frames longer than 2346 bytes by
means of the
Request-to-Send/Clear-to-Send (RTS/CTS)
method.
You must configure a service profile. The
service profile sets the SSID name and other
parameters.
Requires clients to send a separate PSpoll to
retrieve each unicast packet buffered by the
MAP radio.