Radio Profiles - 3Com WX1200 3CRWX120695A Configuration Manual

Encryption
Encrypted SSIDs can use the following encryption methods:
Dynamic WEP is enabled by default.
(For more information, including configuration instructions, see
Chapter 13, "Configuring User Encryption," on page 281.)

Radio Profiles

You can easily assign radio configuration parameters to many radios by
configuring a radio profile and assigning the profile to the radios. To use
a radio, you must assign a profile to the radio. You can enable the radio
when you assign the profile.
Table 12 summarizes the parameters controlled by radio profiles.
Generally, the only radio parameters controlled by the profile that you
need to modify are the SSIDs and, if applicable, Wi-Fi Protected Access
(WPA) settings. The other parameter settings are standard.
For information about the auto-tune parameters, see Table 25 on
page 314.
Table 12 Defaults for Radio Profile Parameters
Parameter
active-scan
beacon-interval
countermeasures Not configured Does not issue countermeasures against any
dtim-interval
Wi-Fi Protected Access (WPA)
Non-WPA dynamic Wired Equivalent Privacy (WEP)
Non-WPA static WEP
Default Value
enable
100
1
Radio Behavior When Parameter Set to
Default Value
Sends probe any requests (probe requests
with a null SSID name) to solicit probe
responses from other access points.
(See "Rogue Detection and
Countermeasures" on page 567.)
Waits 100 ms between beacons.
device.
(See "Rogue Detection and
Countermeasures" on page 567.)
Sends the delivery traffic indication map
(DTIM) after every beacon.
MAP Overview 209