Setting The System Location And Contact Strings; Enabling Snmp Versions; Configuring Community Strings (Snmpv1 And Snmpv2C Only) - 3Com WX1200 3CRWX120695A Configuration Manual

140 C 7: C
HAPTER ONFIGURING
Setting the System
Location and Contact
Strings
Enabling SNMP
Versions
Configuring
Community Strings
(SNMPv1 and
SNMPv2c Only)
SNMP
Set the minimum level of security allowed for SNMP message
exchanges.
Configure a notification profile or modify the default one, to enable
sending of notifications to notification targets. By default,
notifications of all types are dropped (not sent).
Configure notification targets.
Enable the MSS SNMP engine.
To set the location and contact strings for a switch, use the following
commands:
set system location string
set system contact string
Each string can be up to 256 characters long, with no blank spaces.
The following commands set a WX switch's location to 3rd_floor_closet
and set the contact to sysadmin1:
WX4400# set system location 3rd_floor_closet
success: change accepted.
WX4400# set system contact sysadmin1
success: change accepted.
To enable an SNMP protocol, use the following command:
set snmp protocol {v1 | v2c | usm | all} {enable | disable}
The usm option enables SNMPv3. The all option enables all three
versions of SNMP.
The following command enables all SNMP versions:
WX4400# set snmp protocol all enable
success: change accepted.
To configure a community string for SNMPv1 or SNMPv2c, use the
following command:
set snmp community name comm-string
access {read-only | read-notify | notify-only | read-write |
notify-read-write}