3Com WX1200 3CRWX120695A Configuration Manual page 255

Configuring Local Packet Switching on MAPs 255
To clear the VLAN profile that had been applied to MAP 7, type the
following command:
WX# clear ap 7 local-switching vlan-profile
success: change accepted.
Removing a VLAN Profile from the WX Switch
To remove a VLAN profile or individual entries from a VLAN profile, use
the following command:
clear vlan-profile profile-name [vlan vlan-name]
You can use this command to remove individual VLANs from a VLAN
profile, or to remove an entire VLAN profile. If you remove all of the
entries from a VLAN profile, the VLAN profile itself is removed.
If a VLAN profile is changed so that traffic that had been tunneled to a
WX switch is now locally switched by MAPs, or vice-versa, the sessions of
clients associated with the MAPs where the VLAN profile is applied are
terminated, and the clients must re-associate with the MAPs.
To remove the entry for VLAN red from VLAN profile locals type the
following command:
WX# clear vlan-profile locals vlan red
WX#
To remove VLAN profile locals, type the following command:
WX# clear vlan-profile locals
WX#