Clearing Security Acls From The Edit Buffer - 3Com WX1200 3CRWX120695A Configuration Manual

WX1200# display security acl info
ACL information for all
set security acl ip acl-111 (hits #4 0)
----------------------------------------------------
1. permit IP source IP 192.168.254.12 0.0.0.0 destination IP any
2. permit IP source IP 192.168.253.11 0.0.0.0 destination IP any
set security acl ip acl-2 (hits #1 0)
----------------------------------------------------
1. permit L4 Protocol 115 source IP 192.168.1.11 0.0.0.0 destination IP
192.168.1.15 0.0.0.0 precedence 0 tos 0 enable-hits
Clearing Security
ACLs from the Edit
Buffer
WX1200# display security acl info
ACL information for all
set security acl ip acl-111 (hits #4 0)
----------------------------------------------------
1. permit IP source IP 192.168.254.12 0.0.0.0 destination IP any
2. permit IP source IP 192.168.253.11 0.0.0.0 destination IP any
set security acl ip acl-2 (hits #1 0)
----------------------------------------------------
1. permit L4 Protocol 115 source IP 192.168.1.11 0.0.0.0 destination IP
192.168.1.15 0.0.0.0 precedence 0 tos 0 enable-hits
WX1200# display security acl editbuffer
ACL edit-buffer table
ACL
------------------------------- ---- --------------
acl-a
acl-111
3 To view the results, type the following command:
Use the rollback command to clear changes made to the security ACL
edit buffer since it was last committed. The ACL is rolled back to its state
at the last commit command. For example, suppose you want to remove
an ACE that you just created in the edit buffer for acl-111:
1 To display the contents of all committed security ACLs, type the following
command:
2 To view a summary of the security ACLs for which you just created ACEs
in the edit buffer, type the following command:
Type Status
IP
IP
Not committed
Not committed
Modifying a Security ACL 397