3Com WX1200 3CRWX120695A Configuration Manual page 206

206 C 10: C
HAPTER ONFIGURING
MAP A P
CCESS OINTS
Table 10 Defaults for Service Profile Parameters (continued)
Parameter
web-portal-acl
web-portal-form
web-portal-session-
timeout
wep key-index
wep
active-multicast-index
wep
active-unicast-index
wpa-ie
(To configure a service profile, see "Configuring a Service Profile" on
page 233.)
Radio Behavior When Parameter
Default Value Set to Default Value
If set to portalacl and the service profile
portalacl
fallthru is set to web-portal, radios use
Note: This is the
the portalacl ACL to filter traffic for
default only if
Web Portal users during authentication.
the fallthru type
If the fallthru type is web-portal but
on the service
web-portal-acl is set to an ACL other
profile has been
than portalacl, the other ACL is used.
set to
web-portal.
If the fallthru type is not web-portal,
Otherwise, the
radios do not use the web-portal-acl
value is
setting.
unconfigured.
Not configured For WebAAA users, serves the default
login web page or, if configured, the
SSID-specific login web page.
5 Allows a Web Portal WebAAA session
to remain in the Deassociated state 5
seconds before being terminated
automatically.
No keys defined Uses dynamic WEP rather than static
WEP.
Note: If you configure a WEP key for
static WEP, MSS continues to also
support dynamic WEP.
1 Uses WEP key 1 for static WEP
encryption of multicast traffic if WEP
encryption is enabled and keys are
defined.
1 Uses WEP key 1 for static WEP
encryption of unicast traffic if WEP
encryption is enabled and keys are
defined.
disable Does not use the WPA IE in transmitted
frames.