Configuring Member Wx Switches On The Seed; Configuring A Member - 3Com WX1200 3CRWX120695A Configuration Manual

Configuring a Mobility Domain 155
Optionally, you can configure a redundant seed WX switch, which takes
over seed duties if the primary seed becomes unavailable. See
"Configuring Mobility Domain Seed Redundancy" on page 156.
Configuring Member To configure the list of members on the Mobility Domain seed for
WX Switches on the distribution to other member WX switches, use the following command
Seed on the seed WX switch:
set mobility-domain member ip-addr
For example, the following commands add two members with IP
addresses 192.168.12.7 and 192.168.15.5 to a Mobility Domain whose
seed is the current WX:
WX1200# set mobility-domain member 192.168.12.7
success: change accepted.
WX1200# set mobility-domain member 192.168.15.5
success: change accepted.
Each command adds a member identified by its IP address to the list of
Mobility Domain members. If the WX switch from which you enter the
command is not configured as a seed, the command is rejected.
Configuring a To configure a member WX switch in the Mobility Domain, you enter the
Member following command when logged in to the nonseed member WX switch:
set mobility-domain mode member seed-ip ip-addr
This command configures the IP destination address that the member WX
switch uses when communicating with the seed WX switch.
For example, the following command configures the current WX switch
as a member of the Mobility Domain whose seed is 192.168.253.6:
WX1200# set mobility-domain mode member seed-ip 192.168.253.6
success: change accepted.
This command sets the WX switch as a member of the Mobility Domain
defined on the seed device at the identified address. If the WX switch is
currently part of another Mobility Domain or using another seed, this
command overwrites that configuration. After you enter this command,
the member WX switch obtains a new list of members from its new
seed's IP address.