3Com WX1200 3CRWX120695A Configuration Manual page 106

106 C 6: C
HAPTER ONFIGURING AND
WX1200# display interface
* = From DHCP
VLAN Name
---- --------------- --------------- --------------- ------- ----- --------
4 corpvlan
M IP I
ANAGING NTERFACES AND
If the switch is powered down or restarted, MSS does not retain the
values received from the DHCP server. However, if the IP interface goes
down but MSS is still running, MSS attempts to reuse the address when
the interface comes back up.
Configuring the DHCP Client To configure the DHCP client on a
VLAN, use the following command:
set interface vlan-id ip dhcp-client {enable | disable}
The vlan-id can be the VLAN name or number.
The following command enables the DHCP client on VLAN corpvlan:
WX1200# set interface corpvlan ip dhcp-client enable
success: change accepted.
You can configure the DHCP client on more than one VLAN, but the
client can be active on only one VLAN.
To remove all IP information from a VLAN, including the DHCP client and
user-configured DHCP server, use the following command:
clear interface vlan-id ip
This command clears all IP configuration information from the interface.
The IP interface table flags the address assigned by a DHCP server with an
asterisk ( * ). In the following example, VLAN corpvlan received IP address
10.3.1.110 from a DHCP server.
Address
*10.3.1.110
S
ERVICES
Mask Enabled State RIB
255.255.255.0 YES Up ipv4