3Com WX1200 3CRWX120695A Configuration Manual page 82

82 C 5: C
HAPTER ONFIGURING AND
WX1200# display port counters octets port 3
Port Status
===============================================================================
3 Up
M P
ANAGING ORTS AND
Displaying PoE State
To display the PoE state of a port, use the following command:
display port poe [port-list]
To display PoE information for ports 1 and 3, type the following
command:
WX1200# display port poe 1,3
Port Name
===================================================
1 1
3 3
In this example, PoE is disabled on port 1 and enabled on port 3. The
MAP connected to port 3 is drawing 1.44 W of power from the WX
switch.
(For more information about the fields in the output, see the
LAN Switch and Controller Command
Displaying Port Statistics
To display port statistics, use the following command:
display port counters [octets | packets | receive-errors |
transmit-errors | collisions | receive-etherstats |
transmit-etherstats] [port port-list]
You can specify one statistic type with the command. For example, to
display octet statistics for port 3, type the following command:
Rx Octets
27965420
(For information about the fields in the output, see the
Switch and Controller Command
To display all types of statistics with the same command, use the monitor
port counters command. (See "Monitoring Port Statistics" on page 83.)
VLAN
S
Link Port
Status Type
down MAP
up MAP
Reference.)
Reference.)
PoE PoE
config Draw
disabled off
enabled 1.44
Wireless
Tx Octets
34886544
Wireless LAN