Adding A Static Route - 3Com WX1200 3CRWX120695A Configuration Manual

WX1200# display ip route
Router table for IPv4
Destination/Mask
__________________ _______ ______ _______ _______________ _______________
0.0.0.0/ 0 Static
0.0.0.0/ 0 Static
10.0.2.1/24 IP
10.0.2.1/32 IP
10.0.2.255/32 IP
224.0.0.0/ 4 IP

Adding a Static Route

If a VLAN is administratively disabled or all of the links in the VLAN go
down or are disabled, MSS removes the VLAN's routes from the route
table. If the direct route required by a static route goes down, MSS
changes the static route state to Down. If the route table contains other
static routes to the same destination, MSS selects the resolved route that
has the lowest cost. In the following example, the default route to
10.0.1.17 is down, so MSS selects the default route to 10.0.2.17.
Proto Metric NH-Type Gateway
1 Router
2 Router
0 Direct
0 Direct
0 Direct
0 Local
(For more information about the fields in the output, see the
LAN Switch and Controller Command
To add a static route, use the following command:
set ip route {default | ip-addr mask | ip-addr/mask-length}
default-router metric
The metric (cost) can be any number between 0 and 2,147,483,647.
Lower-cost routes are preferred over higher-cost routes. When you add
multiple routes to the same destination, MSS groups the routes together
and orders them from lowest cost at the top of the group to highest cost
at the bottom of the group. If you add a new route that has the same
destination and cost as a route already in the table, MSS places the new
route at the top of the group of routes with the same cost.
To add a default route that uses default router 10.5.4.1 and has a cost of
1, type the following command:
WX1200# set ip route default 10.5.4.1 1
success: change accepted.
Configuring and Managing IP Routes
VLAN:Interface
10.0.1.17 Down
10.0.2.17 vlan:2:ip
vlan:2:ip
vlan:2:ip:10.0.1.1/24
vlan:2:ip:10.0.1.1/24
MULTICAST
Reference.)
111
Wireless