Radius And Server Group Configuration Scenario - 3Com WX1200 3CRWX120695A Configuration Manual

528 C 22: C
HAPTER ONFIGURING
WX1200# display aaa
Default Values
authport=1812 acctport=1813 timeout=5 acct-timeout=5
retrans=3 deadtime=0 key=(null) author-pass=(null)
Radius Servers
Server
-------------------------------------------------------------------
sandpiper
heron
coot
egret
Server groups
RADIUS and Server
Group
Configuration
Scenario
WX1200# set radius server pelican address 192.168.253.11 key elm
WX1200# set radius server seagull address 192.168.243.12 key fir
WX1200# set radius server egret address 192.168.243.15 key pine
WX1200# set radius server sandpiper address 192.168.253.17 key oak
C
OMMUNICATION WITH
The members of the group remain configured, although no server groups
are shown:
Addr
192.168.253.3
192.168.253.1
192.168.253.4
192.168.253.2
The following example illustrates how to declare four RADIUS servers to a
WX switch and configure them into two load-balancing server groups,
swampbirds and shorebirds:
1 Configure RADIUS servers. Type the following commands:
2 Place two of the RADIUS servers into a server group called swampbirds.
Type the following command:
WX1200# set server group swampbirds members pelican seagull
3 Enable load balancing for swampbirds. Type the following command:
WX1200# set server group swampbirds load-balance enable
4 Place the other RADIUS servers in a server group called shorebirds. Type
the following command:
WX1200# set server group shorebirds members egret pelican
sandpiper
5 Enable load balancing for shorebirds. Type the following command:
WX1200# set server group shorebirds load-balance enable
RADIUS
Ports T/o Tries Dead State
1812 1813 5
1812 1813 5
1812 1813 5
1812 1813 5
3 0 UP
3 0 UP
3 0 UP
3 0 UP