Specifying A Backup Configuration File; Resetting To The Factory Default Configuration - 3Com WX1200 3CRWX120695A Configuration Manual

612 C 27: M
HAPTER ANAGING
Specifying a Backup
Configuration File
Resetting to the
Factory Default
Configuration
S F
YSTEM ILES
In the event that part of the configuration file is invalid or otherwise
unreadable, MSS stops reading information in the configuration file and
does not use it. You can optionally specify a backup file to load if MSS
cannot load the original configuration file.
To specify a backup configuration file, use the following command:
set boot backup-configuration filename
To specify a file called backup.cfg as the backup configuration file, use
the following command:
WX1200# set boot backup-configuration backup.cfg
success: backup boot config filename set.
After enabling this feature, you can specify that a backup configuration
file not be used by entering the following command:
WX1200# clear boot backup-config
success: Backup boot config filename was cleared.
To display the name of the file specified as the backup configuration file,
enter the display boot command. For example:
WX1200# display boot
Configured boot version:
Configured boot image:
Configured boot configuration:
Backup boot configuration:
Booted version:
Booted image:
Booted configuration:
Product model:
To reset the WX switch to its factory default configuration, use the
following command:
clear boot config
This command removes the configuration file that the WX switch
searches for after the software is rebooted.
4.1.0.60
wxb04102.rel
file:configuration
backup.cfg
4.1.0.60
wxb04102.rel
file:configuration
WX