3Com WX1200 3CRWX120695A Configuration Manual page 291

Creating a Service Profile for WPA
Encryption parameters apply to all users who use the SSID configured by
a service profile. To create a service profile, use the following command:
set service-profile name
To create a new service profile named wpa, type the following command:
WX1200# set service-profile wpa
success: change accepted.
Enabling WPA
To enable WPA, you must enable the WPA information element (IE) in the
service profile. To enable the WPA IE, use the following command:
set service-profile name wpa-ie {enable | disable}
To enable WPA in service profile wpa, type the following command:
WX1200# set service-profile wpa wpa-ie enable
success: change accepted.
Specifying the WPA Cipher Suites
To use WPA, at least one cipher suite must be enabled. You can enable
one or more of the following cipher suites:
CCMP
TKIP
40-bit WEP
104-bit WEP
By default, TKIP is enabled and the other cipher suites are disabled.
To enable or disable cipher suites, use the following commands:
set service-profile name cipher-ccmp {enable | disable}
set service-profile name cipher-tkip {enable | disable}
set service-profile name cipher-wep104 {enable | disable}
set service-profile name cipher-wep40 {enable | disable}
To enable the 40-bit WEP cipher suite in service profile wpa, type the
following command:
WX1200# set service-profile wpa cipher-wep40 enable
success: change accepted.
Configuring WPA 291