Displaying And Debugging Ip Address - 3Com 5500-SI Configuration Manual

272 C 17: N
HAPTER ETWORK
Displaying and
Debugging IP Address
P O
ROTOCOL PERATION
Perform the following configuration in System View.
Table 266 Configuring the Host Name and the Corresponding IP Address
Operation
Configure the hostname and the corresponding
IP address
Delete the hostname and the corresponding IP
address
By default, there is no host name associated to any host IP address.
For further information on IP Address configuration, please refer to the Getting
Started Guide that accompanies your Switch.
Configuring the IP Address of the VLAN Interface
You can configure an IP address for every VLAN interface of the Switch. Generally, it is
enough to configure one IP address for an interface. You can also configure up to five
IP addresses for an interface, so that it can be connected to several subnets. Among
these IP addresses, one is the primary IP address and all others are secondary.
Perform the following configuration in VLAN Interface View.
Table 267 Configuring the IP Address for a VLAN Interface
Operation
Configure IP address for a
VLAN interface
Delete the IP address of a
VLAN interface
By default, the IP address of a VLAN interface is null.
Note that the VLAN interface cannot be configured with the secondary IP address if
its IP address is set to be allocated by BOOTP or DHCP.
After the above configuration, enter the
IP addresses configured on interfaces of the network device, and to verify the effect
of the configuration.
Table 268 Displaying and Debugging IP Address
Operation
Display all hosts on the network and the
corresponding IP addresses
Display the configurations of each
interface
Command
ip host hostname ip_address
undo ip host hostname [ ip_address ]
Command
ip address ip_address { mask | mask_length } [ sub ]
undo ip address ip-address { mask | mask_length } [ sub
]
display
Command
display ip host
display ip interface vlan-interface
vlan_id
command in any view to display the