Displaying and
Maintaining
Information Center
Information Center
Configuration
Examples
Outputting Log
Information to a Unix
Log Host
In the interaction mode, you are prompted for some information input. If the
■
input is interrupted by system output, no system prompt will be made, rather
only your input will be displayed in a new line.
To do...
Display channel
information for a specified
channel
Display the configurations
on each output destination
Display the state of the log
buffer and the log
information recorded
Display a summary of the
log buffer
Display the state of the
trap buffer and the trap
information recorded
Reset the log buffer
Reset the trap buffer
Network requirements
Send log information to a Unix log host with an IP address of 1.2.0.1/16;
■
Log information with severity higher than informational will be output to the
■
log host;
The source modules are ARP and IP.
■
Network diagram
Figure 302 Network diagram for outputting log information to a Unix log host
1.1.0.1 /16
Device
Configuration procedure
Before the configuration, make sure that there is a route between Device and PC.
1 Configuring the device
# Enable information center.
<Sysname> system-view
[Sysname] info-center enable
Displaying and Maintaining Information Center
Use the command...
display channel [ channel-number |
channel-name ]
display info-center
display logbuffer [ level severity |
size buffersize ] * [ | { begin | exclude
| include } text ]
display logbuffer summary [ level
severity ]
display trapbuffer [ size buffersize ] Available in any view
reset logbuffer
reset trapbuffer
1 .2.0.1/16
Internet
Remarks
Available in any view
Available in any view
Available in any view
Available in any view
Available in user view
Available in user view
PC
1015