Group Identifier - Avaya J100 Series Installing And Administering

Phone administration
5. Use the Right Arrow key to change Network mode to Ethernet and do one of the
following settings:
• Network config: To change the network configuration to either Auto or Manual.
• Ethernet: To change the Ethernet setting, go to step 6.
• PC Ethernet: To change the PC Ethernet setting, go to step 7.
6. Use the Right Arrow key or the Change softkey to change the Ethernet setting to one of
the following:
• Auto
• 10Mbps half
• 10Mbps full
• 100Mbps half
• 100Mbps full
7. Use the Right Arrow key or the Change softkey to change the PC Ethernet setting to one
of the following:
• Auto
• 10Mbps half
• 10Mbps full
• 100Mbps half
• 100Mbps full
• Disabled
8. Press Save.

Group identifier

A group identifier is a number assigned to a particular community of IP phone users in an
organization. The group identifier number can be a number from 0 to 999 and the default number
is 0.
With a group identifier, you can provide administration settings to each phone used by different
communities of end users. For example, you might want to group users by time zones or work
activities.
You can configure group identifier from the phone UI as a local administration process.
Related links
Setting the group identifier
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
on page 97
Comments on this document? infodev@avaya.com
setup 96