Avaya J100 Series Installing And Administering page 161

Parameter name
RECOVERYREGISTERWAIT
REDIRECT_TONE
REGISTERWAIT
REUSETIME
RINGTONES
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
60
1
900
60
Null
setup
Comments on this document? infodev@avaya.com
Appendix A: List of configuration parameters
Description
• 9: The tone volume is 5dB below the
transmit audio level.
• 10: The tone volume is equal to the
transmit audio level.
Specifies a number of seconds. If no
response is received to a REGISTER
request within the number of seconds
specified by
WAIT_FOR_REGISTRATION_TIMER,
the phone will try again after a
randomly selected delay of 50% to
90% of the value of
RECOVERYREGISTERWAIT.
Valid values are 10 through 36000.
Specifies the tone to play when a call
goes to coverage.
Valid values are 1-4.
Specifies the number of seconds
between re-registrations with the
current server.
Specifies the number of seconds that
the DHCP is attempted:
• With a VLAN ID of zero. True when
L2Q is set to 1.
• Or with untagged frames. True if
L2Q is set to 0 or 2.
• And before reusing the IP address
and the associated address
information, that the phone had the
last time it successfully registered
with a call server.
While reusing an address, DHCP
enters the extended rebinding state
described above for DHCPSTD.
Valid values are 0 and 20 through 999.
The default value is 60. A value of
zero means that DHCP will try forever
and there will be no reuse.
Specifies a list of display names and
file names or URLs for a custom ring
Table continues...
161