Avaya J100 Series Installing And Administering page 168

Appendix
Parameter name
SLMCTRL
SLMPERF
SLMPORT
SLMSRVR
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
0
1
50011
setup
Comments on this document? infodev@avaya.com
Description
packets capture using local CRAFT
procedures.
Specifies whether the SLA Monitor
agent is enabled for phone control.
Value Operation
0: Disabled (default)
1: Enabled
2: Controlled from craft menu
Specifies whether the SLA Monitor
agent is enabled for phone
performance monitoring.
Value Operation
0: Disabled (default)
1: Enabled
Specifies the UDP port that will be
opened by the SLA Monitor agent to
receive discovery and test request
messages.
Valid values are 6000 through 65535.
The default value is 50011.
Note:
If default port is not used, both
the SLA Mon agent and the
server must be configured with
the same port. This parameter
impacts the phone's SLA Mon
agent configuration. A
corresponding configuration must
also be made on the SLA Mon
server agentcom-
slamon.conf file.
Specifies the IP address and the port
number of the SLA Mon server in the
aaa.bbb.ccc.ddd:n format.
Set the IP address of the SLA Mon
server in the aaa.bbb.ccc.ddd format
to restrict the registration of agents
only to that server.
Table continues...
168