Avaya J100 Series Installing And Administering page 17

Configuring Wi–Fi using phone UI
About this task
Use this procedure to configure a Wi-Fi network by using phone UI. Note that switching networks
causes a reboot of the phone.
Procedure
1. Press Main Menu > Administration.
2. In the Access code field, enter the administration password.
3. Press Enter.
4. Select Network Interfaces.
5. Use the right arrow key to change Network mode to Wi-Fi.
6. Configure the following fields:
• Network config: Specifies if the WLAN is connected automatically or manually.
• SSID: Specifies the network name for the WLAN you are using. Use the navigation key
to select another SSID.
• Wi-Fi networks: Displays available WLAN.
7. Use the navigation key to select a WLAN and press Connect.
8. Press one of the following:
• Save
• Cancel
• Change
Related links
Wi-Fi overview on page 14
List of Wi-Fi configuration parameters
Parameter Name
WIFISTAT
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default Value
1
setup
Comments on this document? infodev@avaya.com
Hardware setup
Description
Specifies the network interface to
be used for network connectivity.
Value operation:
• 0: Phone connects to only
Ethernet network.
• 1: Phone connects to Ethernet
network, unless manually
switched to Wi—Fi
• 2: Phone connects to the Wi—
Fi network with the SSID
Table continues...
17