Avaya J100 Series Installing And Administering page 169

Parameter name
SLMSTAT
SNMPADD
SNMPSTRING
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
0
Null
Null
setup
Comments on this document? infodev@avaya.com
Appendix A: List of configuration parameters
Description
Specifying a port number is optional. If
you do not specify a port number, the
system takes 50011 as the default
port. If the value of the port number is
0, than any port number is acceptable.
The IP address must be in the dotted
decimal format, optionally followed by
a colon and an integer port number
from 0 to 65535.
To use a non-default port, set the
value in the aaa.bbb.ccc.ddd:n format,
where aaa.bbb.ccc.ddd is the IP
addressof the SLA Mon server.
Note:
If default port is not used, both
the SLA Mon agent and server
must be configured with the same
port. SLMSRVR impacts the
phone's SLA Mon agent
configuration. A corresponding
configuration must also be made
on the SLA Mon server
agentcom-slamon.conf file
Specifies if the SLA Monitor agent is
enabled or not.
Value Operation
0: Disabled (default)
1: Enabled
Specifies a list of source IP addresses
from which SNMP query messages
will be accepted and processed.
Addresses can be in dotted-decimal
format (IPv4), colon-hex format (IPv6,
if supported), or DNS name format,
separated by commas without any
intervening spaces.
The list can contain up to 255
characters. The default value is null.
Specifies a security string that must be
included in SNMP query messages for
the query to be processed.
Table continues...
169