Avaya J100 Series Installing And Administering page 128

Appendix
Parameter name
DIALPLAN
DISCOVER_AVAYA_ENVIRONMENT
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
Null
setup
Comments on this document? infodev@avaya.com
Description
• Or if it will enter an extended
rebinding state in which it continues
to use the address and to
periodically send a rebinding request
• To periodically send an ARP request
to check for address conflicts, until a
response is received from a DHCP
server or until a conflict is detected.
Value Operation
• 0: Continue using the address in an
extended rebinding state.
• 1: Immediately stop using the
address.
Specifies the dial plan used in the
phone.
Dialplan accelerates dialing by
eliminating the need to wait for the
INTER_DIGIT_TIMEOUT timer to
expire.
The value can contain 0 to 1023
characters. The default value is null.
Specifies dynamic feature set
discovery
Value Operation
• 1: The phone discovers and verifies
if the controller supports the AST
feature set or not. The phone sends
a SUBSCRIBE request to the active
controller for the Feature Status
Event Package (avaya-cm-feature-
status). If the request succeeds, the
phone proceeds with PPM
Synchronization. If the request is
rejected, or is proxied back to the
phone, or does not receive a
response, the phone assumes that
AST features are not available.
• 0: The phone operates in a mode
where AST features are not
available.
Table continues...
128