Avaya J100 Series Installing And Administering page 56

Configuring the phone using web interface
Name
Authentication Mode
VLAN
VLAN
VLAN ID
VLAN Separation Mode
VLAN Test - Wait Time for
DHCP Offer
PC Port VLAN ID
Tags to PC Eternet Interface
QoS
Audio Priority (Layer 2)
Signaling Priority (Layer 2)
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Description
The options are:
• Without proxy logoff
• With proxy logoff
• disabled
Specifies the authentication method to be used by 802.1X.
The options are:
• MD5
• TLS
Specifies whether the VLAN tagging is enabled or disabled.
The options are:
• Auto: To support VLAN functionality by using the phone network.
• On: To support the VLAN functionality by using the internal switch of
the phone.
• Off: To disable the VLAN functionality of the phone.
Specifies the VLAN ID. To assign a VLAN ID, type the VLAN ID.
Configure this parameter if the phone uses a different VLAN than the
default data VLAN.
Specifies the VLAN separation mode.
The options are :
• Disable
• Enable
Specifies the wait time interval in seconds to receive a DHCPOFFER
on a non-zero VLAN. The default value is 60 seconds.
Specifies the VLAN ID of the PC port.
Specifies whether the VLAN tags are stripped from Ethernet frames
that leave the computer (PC) port.
The options are:
• Do not remove
• Remove
Specifies the Layer 2 priority value for audio (RTP and RTCP) streams.
Valid priority values are 0 to 7.
Specifies the Layer 2 priority value for signaling protocol messages.
Valid priority values are 0 to 7.
setup
Comments on this document? infodev@avaya.com
Table continues...
56