Avaya J100 Series Installing And Administering page 45

option between 128 to 254. Whichever option you select , you must specify that number in the
Site-Specific Option Number (SSON) parameter by using the device interface.
The following is an example of the DHCP 242 option string that specifies the HTTPSRVR and the
Voice VLAN that the device must connect to.
HTTPSRVR=10.138.251.67,L2QVLAN=1104
The following table lists the site-specific configuration parameters that you can define for the
device:
Parameter Description
ADMIN_PAS Specifies the security string used to access local procedures. The string can contain
SWORD alphanumeric characters. The default is 27238. This parameter replaces PROCPSWD as
it provides a more secure password syntax.
HTTPDIR Specifies the path to prepend to all configurations and data files that the device might
request when starting up. This path is relative to the root of the HTTP file server and also
to the directory in which the device configuration and date files are stored. The path might
contain maximum 127 characters without spaces. HTTPDIR is the path for all HTTP
operations.
The command is SET HTTPDIR=<path>. In configurations where the upgrade and
binary files are in the default directory on the HTTP server, do not use HTTPDIR=<path>.
HTTPPORT Specifies the destination port for HTTP requests. The default is 80.
HTTPSRVR The firmware files are digitally signed, so TLS is not required for security.
ICMPDU Controls the extent to which ICMP Destination Unreachable messages are sent in
response to messages sent to closed ports so as not to reveal information to potential
hackers. The default is 1, which sends Destination Unreachable messages for the closed
ports used by traceroute.
ICMPRED Controls whether ICMP Redirect messages are processed. The default is 0 in which
redirect messages are not processed.
L2Q Specifies the 802.1Q tagging mode. The default is 0 for automatic.
L2QVLAN Specifies the VLAN ID of the voice VLAN. The default is 0.
PHY1STAT Controls the Ethernet line interface speed. The default is 1 for auto-negotiate.
PHY2STAT Controls the secondary Ethernet interface speed. The default is 1 for auto-negotiate.
PROCPSWD Specifies the security string used to access local procedures. The string can contain only
four numeric characters. The default is 27238.
PROCSTAT Controls whether local procedures are enabled. The default is 0 for enabled.
REUSETIME Specifies the time in seconds for IP address reuse. The default is 60 seconds.
SIP_CONTR Specifies the SIP proxy or registrar server IP or DNS addresses. The list contains 0 to 255
OLLER_LIST characters. The IP address must be in the dotted decimal name format, separated by
commas and without intervening spaces. The default is null.
TLSDIR Specifies the path to all file names used in HTTPS GET operations during initialization.
The path name is prepended. The string can be from 0 to 127 characters long.
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
setup
Comments on this document? infodev@avaya.com
Phone installation
Table continues...
45