Avaya J100 Series Installing And Administering page 130

Appendix
Parameter name
DSCPAUD
DSCPAUD_FL
DSCPSIG
DSCPVID
DSTOFFSET
DSTSTART
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
46
43
34
34
1
2SunMar2L
setup
Comments on this document? infodev@avaya.com
Description
0: Supplicant disabled
1: Supplicant enabled, but responds
only to received unicast EAPOL
messages
2: Supplicant enabled; responds to
received unicast and multicast EAPOL
messages
Specifies the layer 3 Differentiated
Services (DiffServ) Code Point for
audio frames generated by the phone.
Valid values are from 0 to 63.
This parameter can also be set
through the LLDP, which overwrites
any value set in this file.
Specifies the layer 3 Differentiated
Services Code Point Flash
precedence/priority level value for
audio frames generated by the phone.
Valid values are from 0 to 63.
Specifies the layer 3 Differentiated
Services (DiffServ) Code Point for
signaling frames generated by the
phone.
Valid values are 0 through 63.
This parameter can also be set
through LLDP, which overwrites any
value set in this file.
Specifies the layer 3 Differentiated
Services (DiffServ) Code Point for
video frames generated by the phone.
Valid values are 0 through 63. The
default value is 34.
Specifies the time offset in hours of
daylight savings time from local
standard time.
Valid values are 0, 1, or 2. The default
value is 1.
Specifies when to apply the offset for
daylight savings time.
Table continues...
130