Avaya J100 Series Installing And Administering page 138

Appendix
Parameter name
ENABLE_SIP_USER_ID
ENABLE_STRICT_USER_VALIDATION
ENABLE_UDP_TRANSPORT
ENHDIALSTAT
ENTRYNAME
EVENT_NOTIFY_AVAYA_MAX_USERS
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
0
0
1
1
0
20
setup
Comments on this document? infodev@avaya.com
Description
Specifies that the SIP User ID field is
required under ADMIN > SIP > SIP
Global Settings.
Value Operation
• 0: Disabled
• 1: Enabled
Specifies that the validation is done for
the To header and Request-URI
against AOR and Contact header
during phone registration.
Value Operation
• 0: No validation.
• 1: Validates the phone registration.
Specifies that the UDP option is
available on the phone user interface
for selection. The UDP option is
available along with TCP and TLS.
Value Operation
• 0: Disabled
• 1: Enabled
Specifies if the algorithm defined by
the parameter is used during certain
dialing behaviors.
Value Operation
• 0: Disables algorithm.
• 1: Enables algorithm, but not for
contacts.
Specifies if the calling party name, or
the VDN or the skill name must be
used in History entries.
Value Operation
• 0: Calling Party Name is used.
• 1: VDN or the skill name is used.
Specifies the maximum number of
users to be included in an event
notification message from CM/AST-II .
Valid values are 0 through 1000.
Table continues...
138