Avaya J100 Series Installing And Administering page 125

Parameter name
CONNECTION_REUSE
CONTACT_NAME_FORMAT
CONTROLLER_SEARCH_INTERVAL
COUNTRY
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
1
0
16
setup
Comments on this document? infodev@avaya.com
Appendix A: List of configuration parameters
Description
Valid values contain zero or one IP
address in dotted decimal or DNS
name format, optionally followed by a
colon and a TCP port number.
The value can contain 0 to 255
characters. The default value is null.
Specifies whether the phone will use
two UDP, TCP, or TLS connection (for
both outbound and inbound) or one
UDP, TCP, or TLS connection.
Value operation:
• 0: Disabled. The phone opens
outbound connection to the SIP
Proxy and listening socket for
inbound connection from SIP proxy
in parallel.
• 1: Enabled. The phone does not
open a listening socket and will
maintain and re-use the sockets it
creates with the outbound proxies.
Note:
On Avaya J129 IP Phone, only 1 is
supported.
Specifies how contact names are
displayed.
Value operation:
• 0: The name format is Last name,
First name.
• 1: The name format is First name,
Last name.
Specifies the number of seconds the
phone will wait to complete the
maintenance check for monitored
controllers.
Valid values are 4 through 3600.
Used for network call progress tones.
• For Argentina use keyword
Argentina.
• For Australia use keyword Australia.
Table continues...
125