Avaya J100 Series Installing And Administering page 127

Parameter name
DES_STAT
DHCPSTAT
DHCPSTD
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
2
1
0
setup
Comments on this document? infodev@avaya.com
Appendix A: List of configuration parameters
Description
Specifies if DES discovery is to be
attempted during the boot process if
there is no configuration file server
provisioned on the phone.
Value operation:
• 0: DES discovery is allowed.
• 1: DES discovery is not attempted.
DES can still be initiated from the
Administration menu.
• 2: DES discovery is prohibited .
Specifies if DES discovery is to be
attempted during the boot process if
there is no configuration file server
provisioned on the phone.
Value operation:
• 0: DES discovery is disabled and
can only be restored with Reset to
Defaults
• 1: DES discovery is disabled
• 2: DES discovery is enabled
Specifies whether DHCPv4, DHCPv6,
or both will be used in case IPv6
support is enable by using IPV6STAT.
Value operation:
• 1: Run DHCPv4 only. IPv4only-
mode, if no own IPv6 address is
programmed statically
• 2: Run DHCPv6 only. Pv6only-
mode, if no own IPv4 address is
programmed statically
• 3: Run both DHCPv4 & DHCPv6.
Dual-stack mode
Value 2 or 3 run both DHCPv4 and
DHCPv6.
Specifies if DHCP complies with the
IETF RFC 2131 standard:
• And immediately stops using an IP
address if the lease expires
Table continues...
127