Avaya J100 Series Installing And Administering page 124

Appendix
Parameter name
CLDISPCONTENT
CONFERENCE_FACTORY_URI
CONFERENCE_TYPE
CONFIG_SERVER
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
1
Null
1
Null
setup
Comments on this document? infodev@avaya.com
Description
Specifies whether the name, the
number, or both will be displayed for
Call Log entries.
Value Operation
• 0: Both the name and the number
will be displayed.
• 1: Only the name will be displayed
(default).
• 2: Only the number will be
displayed.
Specifies the URI for conference for
Network Conferencing in third-party
call control setup.
Valid values contain zero or one URI,
where a URI consists of a dial string
followed by @, and then the domain
name, which must match the routing
pattern configured in System Manager
for Adhoc Conferencing.
Depending on the dial plan, the dial
string can need a prefix code, such as
a 9 to get an outside line. The domain
portion of the URI can be in the form
of an IP address or an FQDN.
The value can contain 0 to 255
characters. The default value is null.
Determines the selection of the
Conference Method.
Value operation:
• 0: Local conferencing is supported
based on sipping services.
• 1: Server based conferencing is
supported.
• 2: Click-to conference server based
conferencing is supported.
If the parameter is set to a value that
is outside the range then default value
is selected.
Specifies the address of the Avaya
configuration server.
Table continues...
124