Avaya J100 Series Installing And Administering page 131

Parameter name
DSTSTOP
DTMF_PAYLOAD_TYPE
E
EASG_SITE_AUTH_FACTOR
EASG_SITE_CERTS
EEESTAT
ELD_SYSNUM
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
1SunNov2L
120
Null
Null
1
1
setup
Comments on this document? infodev@avaya.com
Appendix A: List of configuration parameters
Description
The default value is 2SunMar2L (the
second Sunday in March at 2AM local
time).
Specifies when to stop applying the
offset for daylight savings time.
The default value is 1SunNov2L (the
first Sunday in November at 2AM local
time).
Specifies the RTP payload type to be
used for RFC 2833 signaling.
Valid values are 96 through 127.
Specifies Site Authentication Factor
code associated with the EASG site
certificate being installed. Valid values
are 10 to 20 character alphanumeric
string.
Specifies list of EASG site certificates
which are used by technicians when
they don't have access to the Avaya
network to generate EASG responses
for SSH login. The URLs must be
separated by commas without any
intervening spaces. Valid values are 0
to 255 ASCII characters.
Specifies Energy-Efficient Ethernet
(802.3az) is enabled on PHY1 and
PHY2.
Value operation:
• 0: EEE is disabled on both PHY1
and PHY2.
• 1; EEE is enabled on both PHY1
and PHY2.
This parameter is supported by only
Avaya J129 IP Phone.
Controls whether Enhanced Local
Dialing algorithm will be applied for
System Numbers-Busy Indicators and
Auto Dials.
Table continues...
131