Avaya J100 Series Installing And Administering page 33

Parameter name
VLANSEPMODE
PHY2TAGS
L2QVLAN
PHY2VLAN
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default value
1
0
0
0
setup
Comments on this document? infodev@avaya.com
Phone installation
Description
• A name equal to value pair in
DHCPACK message
Specifies whether the VLAN
separation is enabled or disabled.
Value operation:
• 0: Disabled
• 1: Enabled
VLANSEPMODE is configured
through the settings file.
Determines whether or not VLAN
tags are stripped on Ethernet
frames going out of the Computer
(PC) port.
Value operation:
• 0: Strip tags. VLAN tags are
stripped from Ethernet frames
leaving the computer (PC) port
of the phone.
• 1: Does not strip tags. VLAN
tags are not stripped from
Ethernet frames leaving the
Computer (PC) port of the
phone.
PHY2TAGS is configured through
the settings file.
Specifies the voice VLAN ID to be
used by IP phones.
Valid values are 0 through 4094.
L2QVLAN is configured through:
• Local admin procedure
• A name equal to value pair in
DHCPACK message
• SET command in a settings file
• DHCP option 43
• LLDP
Specifies the value of the 802.1Q
VLAN ID that is used to identify
network traffic going into and
Table continues...
33