Avaya J100 Series Installing And Administering page 57

Name
Audio DiffServ (Layer 3)
Signaling DiffServ (Layer 3)
LLDP
LLDP
Interface
Ethernet
PC Ethernet
PC Ethernet auto-MDIX
Related links
Configuring Ethernet settings
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Description
Specifies the layer 3 Differentiated Services (DiffServ) code point for
audio frames generated by the phone. Valid values are 0 to 63.
Specifies the layer 3 Differentiated Services (DiffServ) code point for
signaling frames generated by the phone. Valid values are 0 to 63.
Specifies the status of LLDP.
The options are:
• Disabled
• Enabled
• Enabled- only if LLDP frame is received
Specifies the speed and duplex settings for the Ethernet line interface.
The options are:
• auto-negotiate
• 10Mbps half-duplex
• 10Mbps full-duplex
• 100Mbps half-duplex
• 100Mbps full-duplex
Specifies the speed and duplex settings for the secondary (PC)
Ethernet interface.
The options are:
• auto-negotiate
• 10Mbps half-duplex
• 10Mbps full-duplex
• 100Mbps half-duplex
• 100Mbps full-duplex
• Disable
Specifies the status of the auto-MDIX Value Operation.
The options are:
• Enable
• Disable
on page 54
setup
Comments on this document? infodev@avaya.com
Configuring Ethernet settings
57