Avaya J100 Series Installing And Administering page 163

Parameter name
RTCPCONT
RTCPMON
RTCPMONPERIOD
RTCPMONPORT
RTP_PORT_LOW
RTP_PORT_RANGE
S
SCEPPASSWORD
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
Null
5
5005
$SERIALNO
setup
Comments on this document? infodev@avaya.com
Appendix A: List of configuration parameters
Description
• 1: Yes
Specifies if the sending of RTCP is
enabled.
• 0: No
• 1: Yes
Specifies the IP or DNS address for
the RTCP monitor.
You can set this parameter only if the
environment is not an Avaya
environment. The values can range
from 0 through 255 characters.
Specifies the interval, in seconds, for
sending out RTCP monitoring reports.
Valid values are from 5 to 30 seconds.
Specifies the RTCP monitor port
number.
You can set this parameter only if the
environment is not an Avaya
environment. The values can range
from 0 through 65535. Default is 5005.
Specifies the lower limit of the UDP
port range to be used by RTP or
RTCP connections.
The values can range from 1024
through 65503.
Specifies the range or number of UDP
ports available for RTP or RTCP
connections
This value is added to
RTP_PORT_LOW to determine the
upper limit of the UDP port range.
The values can range from 32 through
64511.
Specifies the password to be included
in the challengePassword attribute
of an SCEP certificate request.
Values can contain 0 to 32 ASCII
characters (50 ASCII characters.
Table continues...
163