Avaya J100 Series Installing And Administering page 139

Parameter name
EXCHANGE_AUTH_USERNAME_FORMAT
EXTEND_RINGTONE
F
FAILED_SESSION_REMOVAL_TIMER
FAST_RESPONSE_TIMEOUT
FIPS_ENABLED
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
0
Null
30
4
0
setup
Comments on this document? infodev@avaya.com
Appendix A: List of configuration parameters
Description
This parameter is used only for
development and debugging
purposes.
Specifies the necessary format of the
username for http authentication.
Value operation:
• 0: Office 2003/Office2016 username
format. Username=
<ExchangeUserDomain
\ExchangeUserAccount> or
Username=
<ExchangeUserAccount> if
<ExchangeUserDomain> is empty.
• 1: Office 365 format. Username=
<ExchangeUserAccount@Exchange
UserDomain> or Username=
<ExchangeUserAccount> if
<ExchangeUserDomain> is empty.
Provides a way to customize ring tone
files.
This is a comma separated list of file
names in xml format.
Specifies the number of seconds the
phone displays a session line
appearance and generates re-order
tone after an invalid extension is
dialed and user does not press the
End Call softkey.
Valid values are 5 through 999. The
default value is 30.
Specifies the number of seconds the
phone will waits before terminating an
INVITE transaction if no response is
received.
Valid values are 0 through 32.
Value of 0 means that this timer is
disabled.
Specifies whether the usage of
FIPS-140 approved cryptography is
enabled or not.
Table continues...
139