Avaya J100 Series Installing And Administering page 36

Initial setup and connectivity
Category
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
Avaya Proprietary
Avaya Proprietary
Avaya Proprietary
Avaya Proprietary
Basic Mandatory
TLV impact on system parameter values
System parameter
name
PHY2VLAN
L2QVLAN and L2Q IEEE 802.1 VLAN
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
TLV Name (Type) TLV Info String (Value)
Network Policy Tagging Yes/No, VLAN ID for voice, L2 Priority, DSCP Value.
Inventory – MODEL - Full Model Name.
Hardware Revision
Inventory – Firmware version.
Firmware Revision
Inventory – Software version or filename.
Software Revision
Inventory – Serial Device serial number.
Number
Inventory – Avaya.
Manufacturer
Name
Inventory – Model MODEL with the final Dxxx characters removed.
Name
Call Server IP Call Server IP Address. Subtype = 3.
address
IP Phone Phone IP address, Phone Address Mask, Gateway IP
addresses Address. Subtype = 4.
File Server File Server IP Address. Subtype = 6.
802.1Q Framing 802.1Q Framing = 1 if tagging or 2 if not.
End-of-LLDPDU Not applicable.
TLV name Impact
IEEE 802.1 Port The value of the PHY2VLAN parameter on the phone is
VLAN ID configured from the value of the Port VLAN identifier in the
TLV.
The value is changed to the TLV VLAN Identifier. L2Q is set to
Name 1 (ON).
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the
parameters L2Q or L2QVLAN.
VLAN Name TLV is ignored if:
• The value of USE_DHCP is 0 and the value of IPADD is not
0.0.0.0.
• The current value of L2QVLAN was set by a TIA LLDP MED
Network Policy TLV.
Comments on this document? infodev@avaya.com
setup
Table continues...
36