Avaya J100 Series Installing And Administering page 49

Device upgrade process
1. During boot-up, the phone receives the file server address from DHCP, LLDP, or the device
interface.
2. The phone contacts the provisioning server to download the firmware upgrade file,
J100Supgrade.txt.
3. In J100Supgrade.txt, the APPNAME parameter contains the firmware version.
4. The phone compares the currently installed software version with the version specified in
the APPNAME parameter.
5. If the firmware version specified in the APPNAME parameter is higher, the phone
downloads the software files for upgrade.
6. The phone automatically restarts to apply the upgraded firmware
Tip:
The upgrade events are logged under NOTICES level in the Syslog file.
Post installation checklist
To ensure that the phone is properly installed and running properly, verify that the following
requirements are complete.
No. Task
1 Has the phone acquired an IP
address?
2 Are you able to make a call from the
phone?
3 Are you able to perform backup-
restore?
3 Are you able to modify the phone's
Settings file parameters and end user
settings.
4 Are you able to upgrade your phone?
5 Have you installed the appropriate
private network authentication
certificates?
6 It is critical that you verify Emergency
calling is working properly in your
network. It may be necessary to
make arrangements with the
appropriate authorities to test this
functionality.
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Reference
Configuration parameters
page 118
Device upgrade process
page 49
For more information, see
Administering emergency
numbers
setup
Comments on this document? infodev@avaya.com
Phone installation
on
on
49