Avaya J100 Series Installing And Administering page 155

Parameter name
PHONE_LOCK_IDLETIME
PHY1STAT
PHY2_AUTOMDIX_ENABLED
PHY2PRIO
PHY2STAT
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
5
1
1
0
1
setup
Comments on this document? infodev@avaya.com
Appendix A: List of configuration parameters
Description
Specifies the interval of idle time, in
minutes, after which the phone will
automatically lock.
Specifies the speed and duplex
settings for the Ethernet line interface.
Value Operation
• 1: auto-negotiate
• 2: 10Mbps half-duplex
• 3: 10Mbps full-duplex
• 4: 100Mbps half-duplex
• 5: 100Mbps full-duplex
• 6: 1Gbps full-duplex, if supported by
hardware, otherwise auto-negotiated
Specifies whether auto-MDIX is
enabled on PHY2.
Value Operation
• 0: auto-MDIX is disabled.
• 1: auto-MDIX is enabled.
Specifies the layer 2 priority value to
be used for frames received on the
secondary Ethernet interface when
VLAN separation is enabled.
Valid values are 0 through 7.
Specifies the speed and duplex
settings for the secondary (PC)
Ethernet interface.
Value Operation
• 0: disabled
• 1: auto-negotiate
• 2: 10Mbps half-duplex
• 3: 10Mbps full-duplex
• 4: 100Mbps half-duplex
• 5: 100Mbps full-duplex
• 6: 1Gbps full-duplex, if supported by
hardware, otherwise auto-negotiated
Table continues...
155