Avaya J100 Series Installing And Administering page 37

System parameter
name
L2Q, L2QVLAN,
L2QAUD,
DSCPAUD
L2Q, L2QVLAN
SIP_CONTROLL
ER_LIST
TLSSRVR and
HTTPSRVR
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
TLV name Impact
• The VLAN name in the TLV does not contain the substring
"voice" in lower-case, upper-case or mixed-case ASCII
characters anywhere in the VLAN name.
TIA LLDP MED L2Q - set to 2 (off) if T (the Tagged Flag) is set to 0 and to 1
Network Policy (on) if T is set to 1.
(Voice) TLV
L2QVLAN - Set to the VLAN ID in the TLV.
L2QAUD - Set to the Layer 2 Priority value in the TLV.
DSCPAUD - Set to the DSCP value in the TLV.
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the
parameters L2Q or L2QVLAN.
This TLV is ignored if:
• The value of USE_DHCP is 0 and the value of IPADD is not
0.0.0.0.
• The Application Type is not 1 (Voice) or 2 (Voice Signaling).
• The Unknown Policy Flag (U) is set to 1.
TIA LLDP MED L2Q - set to 2 (off) if T (the Tagged Flag) is set to 0 and to 1
Network Policy (on) if T is set to 1.
(Voice Signaling)
L2QVLAN - Set to the VLAN ID in the TLV.
L2QAUD - Set to the Layer 2 Priority value in the TLV.
DSCPAUD - Set to the DSCP value in the TLV.
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the
parameters L2Q or L2QVLAN.
This TLV is ignored if:
• The value of USE_DHCP is 0 and the value of IPADD is not
0.0.0.0.
• The Application Type is not 1 (Voice) or 2 (Voice Signaling).
• The Unknown Policy Flag (U) is set to 1.
Proprietary Call SIP_CONTROLLER_LIST will be set to the IP addresses in
Server TLV this TLV value.
Proprietary File
Server TLV
Comments on this document? infodev@avaya.com
Note:
This parameter cannot be used in an environment where
both SIP phones and H.323 phones exist.
setup
Phone installation
Table continues...
37