Ethernet Settings Field Descriptions - Avaya J100 Series Installing And Administering

Ethernet settings field descriptions

Name
IP Configuration
Use DHCP
Continue to use DHCP
information after lease expiry
IP Address re-use time
IP Address
Subnet Mask
Gateway IP Address
802.1X
Supplicant Operating Mode
Pass-through Operating Mode Specifies the 802.1X pass-through operating mode.
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Description
Provides the IP address to your phone automatically or manually.
The options are:
• Yes: To assign the IP address automatically to your phone.
• No: To assign the IP address manually to your phone.
Note that, to assign the IP address manually, you must also configure
the IP Address, Subnet Mask, and Gateway IP Address fields
manually.
Specifies whether the DHCP information can be used after the lease
expires.
The options are:
• Yes: To use the assigned IP address after the DHCP lease expires.
• No: To stop using the assigned IP address after the DHCP lease
expires.
Specifies the time in seconds to re-use the assigned IP address after
the DHCP lease expires. The default value is 60 seconds.
Specifies the IP address of the phone. .
Specifies the network mask address. To assign the network mask
address manually to your phone, type the address in the corresponding
field.
Specifies the IP address of the gateway. To assign the gateway IP
address manually to your phone, type the address in the corresponding
field.
Specifies the 802.1X supplicant operating mode.
The options are:
• Disabled
• Unicast
• Multicast
Pass-through refers to the forwarding of EAPOL frames between the
phone's Ethernet line interface and the secondary PC Ethernet
interface.
setup
Comments on this document? infodev@avaya.com
Configuring Ethernet settings
Table continues...
55