Avaya J100 Series Installing And Administering page 78

Configuring the phone using web interface
Name
G.711a law
Send DTMF
G.726 Payload
DTMF Payload
RTP
Play Tone till RTP
Symmetric RTP
RTCP_XR
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Description
Specifies whether the G.711a law codec is enabled.
The options are:
• Disable
• Enable
Specifies whether the phone sends DTMF tones in-band as regular audio,
or out-of-band using RFC 2833 procedures.
The options are:
• In-band
• Out-of-band
Specifies the RTP payload type to be used for the G.726 codec.
The default value is 110.
Valid values are from 96 to 127.
Specifies the RTP payload type to be used for RFC 2833 signaling.
The default value is 120.
Valid values are from 96 to 127.
Specifies whether the locally generated ringback tone stops when SDP is
received for an early media session, or whether it continues until RTP is
actually received from the far-end party.
The options are:
• Yes
• No
Specifies whether the phone must receive RTP if the UDP source port
number is not same as the UDP destination port number.
The options are:
• Disable
• Enable
The default value is Enable. tag
Specifies whether VoIP Metrics Report Block as defined in RTP Control
Protocol Extended Reports (RTCP XR) (RFC 3611) is sent as part of the
RTCP packets to a remote peer or an RTCP monitoring server.
The options are:
• Yes
• No
The default value is No.
setup
Comments on this document? infodev@avaya.com
Table continues...
78