Avaya J100 Series Installing And Administering page 151

Parameter name
MYCERTKEYLEN
MYCERTRENEW
MYCERTURL
MYCERTWAIT
N
NO_DIGITS_TIMEOUT
O
OCSP_ACCEPT_UNK
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
2048
90
Null
1
20
1
setup
Comments on this document? infodev@avaya.com
Appendix A: List of configuration parameters
Description
Specifies the bit length of the public
and private keys generated for the
SCEP certificate request.
The value is a 4 ASCII numeric digits.
The minimum value is 2048.
Specifies the percentage of the
identity certificate's validity interval
after which renewal procedure is
initiated.
Valid values are 1 through 99.
Specifies the URL of the SCEP server
for obtaining an identity certificate. If
the URL is specified in HTTPS, then
the HTTPS is used to send the CSR to
the SCEP server.
The valid values can range from Zero
to 255 ASCII characters. The default
value is null .
Specifies the phone's behavior if the
SCEP server indicates that the
certificate request is pending for
manual approval.
Value Operation
• 0: Poll the SCEP server periodically
in the background.
• 1: Wait until a certificate is received
or the request is rejected.
Specifies the number of seconds the
phone waits for a digit to be dialed
after going off-hook and before
generating a warning tone.
Valid values are 1 through 60.
Specifies that whether to close a TLS
connection during an unknown
certificate revocation status. Value
operation:
• 0: Certificates are revoked and the
TLS connection is closed.
Table continues...
151