Rear Door Window Regulator Removal And Installation; Rear Door Window Regulator Inspection; Rear End Door Window Defogger Switch Inspection - Suzuki 2006 SX4 Service Manual

Rear Door Window Regulator Removal and
Installation
Removal
1) Remove door glass referring to "Rear Door Glass
Removal and Installation".
2) Disconnect power window motor lead wire at
coupler.
3) Loosen regulator mounting screws, and then remove
rear window regulator (1).
1
Installation
Reverse removal procedure noting the following.
• Apply grease to sliding and rotating portions of
window regulator.
: Grease 99000–25011 (SUZUKI Super Grease A)
• Tighten rear door window regulator attaching screws.
Rear door window regulator screw tightening
order
(1) → (2)

Rear Door Window Regulator Inspection

Check the following point:
• Check regulator sliding and rotating parts.
• Check rollers for wear and damage.
Rear End Door Window Defogger Switch
Inspection
S6RW0D9506015
1) Check rear end door window defogger switch for
If check result does not meet the above conditions,
replace HVAC control module (unit).
I5RW0A950031-01
2
1
2
I5RW0A950032-01
[A]: Manual A/C model
[B]: Auto A/C model
S6RW0D9506016
Glass / Windows / Mirrors:
operation as follows.
a) Rear end door window defogger switch is built in
HVAC control unit.
Remove HVAC control module (unit) referring to
"HVAC Control Unit Removal and Installation in
Section 7A" or "HVAC Control Module Removal
and Installation in Section 7B".
b) Check that there is continuity between terminal
(1) and terminal (2) of HVAC control module
(unit) when rear end door window defogger
switch is at ON position. (Rear end door window
defogger switch is kept in push.)
c) Check that there is no continuity between
terminal (1) and terminal (2) of HVAC control
module (unit) when rear end door window
defogger switch is at OFF position.
[A]
1 2
[B]
1
9E-18
S6RW0D9506017
2
I5RW0A950033-01