Dsploads - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

dsploads

dsploads
Display Loads
Use the dsploads command to view the connection load for all ports on the current AUSM. This
command helps you to determine whether adding more connections is advisable.
The display shows the load in cells per second. If the traffic is exceeding the bandwidth configured for
the port, an "overload" message appears at the bottom of the column for the overloaded port.
Syntax
dsploads
Related Commands
None
Attributes
Log: No
Example
Display the loads on the current AUSM.
PXM1E_SJ.1.1.AUSMB8.a > dsploads
CBR
VBR
ABR
UBR
rt-VBR
Total
CBR (based on PCR0+1)
VBR (based on PCR0+1)
ABR (based on MCR)
UBR (based on PCR0+1)
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-154
State: Active
Load Display for ATM UNI and IMA ports
Port 1
***************************************************************
Egress direction (Based on EgrSrv rate for all service types)
0
0
0
0
0
--------------------------------------------------------------
0
Ingress direction
0
0
0
0
Privilege: Any User
Port2 Port3 Port4
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Chapter 4 AUSM Command Reference
Port5 Port6 Port7
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
Port8
0
0
0
0
0
0
0
0
0
0