Chapter 4
AUSM Command Reference
dspimagrp
Display IMA Group
Use the dspimagrp command to view the current configuration for an IMA group.
Syntax
dspimagrp <group_num>
Syntax Description
group_num
Related Commands
addimagrp, addlns2imagrp, cnfimagrp, delimagrp, dellnsfmimagrp, dspimagrps
Attributes
Log: No
Example
Display the configuration for IMA group 1 on the current card.
PXM1E_SJ.1.1.AUSMB8.a > dspimagrp 1
IMA Group number
Port type
Lines configured
Enable
IMA Port state
IMA Group Ne state
PortSpeed (cells/sec)
GroupTxAvailCellRate (cells/sec) : 14364
ImaGroupTxFrameLength(cells)
LcpDelayTolerance (IMA frames)
ReadPtrWrPtrDiff
Minimum number of links
MaxTolerableDiffDelay (msec)
Lines Present
Observed Diff delay (msec)
Clock Mode
GroupAlpha
GroupBeta
GroupGamma
GroupConfiguration
IMAGrp Failure status
Timing reference link
ImaGroupTxImaId
ExpectedGroupRxImaId
PXM1E_SJ.1.1.AUSMB8.a >
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Enter the number for the IMA group you want to display. Use the dspimagrps
command to display the configured IMA groups.
State: Active
(cells)
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
Privilege: Group 1
: 1
: NNI
: 1.2.3.4
: Enabled
: Active
: operational
: 14364
: 128
: 1
: 4
: 3
: 275
: 1.2.3.4
: 0
: CTC
: 2
: 2
: 1
: 1
: No Failure
: 1
: 0x0
: 0x0
dspimagrp
4-143