Cnfaimgrp - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

Chapter 4 AUSM Command Reference

cnfaimgrp

Configure AIM Group
Use the cnfaimgrp command to change the minimum number of lines required for IMA group operation
(set with addimagrp) or to change the maximum differential delay setting for the group.
Syntax
cnfaimgrp <group_num> <max_diff_delay> <minNumLink>
Syntax Description
group_num
max_diff_delay
minNumLink
Related Commands
addaimgrp, addlns2imagrp, delaimgrp, dellnsfmimagrp, dspaimgrp, dspaimgrps
Attributes
Log: Yes
Example
Configure IMA group 1 for the default 275 ms maximum differential delay, and set the minimum number
of lines to 2.
PXM1E_SJ.1.1.AUSMB8.a > cnfaimgrp 1 275 2
PXM1E_SJ.1.1.AUSMB8.a >
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Enter the number for the IMA group you want to configure. Use the
dspimagrps command to display the configured IMA groups.
Specify the maximum tolerable differential delay between the various links in
the IMA group in the range appropriate for the SM type.
• AUSM8-T1: 0–275 ms
• AUSM8-E1: 0–200 ms
Enter the minimum number of lines required for group operation. For example,
if you create an IMA group of 4 lines and specify a minimum number of 3 lines,
then three of the four specified lines must be operational before the IMA group
can be used. The range for this value is from 1 to n, where n represents the
number of lines that are dedicated to the group.
State: Active
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
Privilege: Group 1
cnfaimgrp
4-51