Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference page 55

Chapter 2 Provisioning Communications Links
Step 4 To display the configuration information for a specific SPVC endpoint, enter the following command:
PXM1E_SJ.1.4.AUSMB8.a > dspcon <port_num> <vpi> <vci>
The port, VPI, and VCI numbers are listed in the dspcons command display.
The following is sample output from the dspcon command for the connection created in the previous
example. Notice that this report shows the NSAP IDs for both ends of the connection.
PXM1E_SJ.1.4.AUSMB8.a > dspcon 2 100 100
-------------------------------------------
ChanNum:
AdmnState: Up
---------- ---------- ---------- ----------
PORT-ALARM CTRLR-ABIT E-AIS/RDI
---------- ---------- ---------- ----------
-------------------------------------------
ChanNum:
RowStatus:
ConnAdminStatus:
ConnectionType:
ServiceType:
ChanSvcFlag:
PortNum:
VPI:
VCI (For VCC):
Local VPId(for VPC):
EgressQNum:
IngressQDepth(cells):
IngressDiscardOption:
IngressFrameDiscardThreshold
IngressQCLPHigh(cells):
IngressQCLPLow(cells):
QCLPState:
IngressEfciThreshold(cells):
UPCEnable:
PeakCellRate[0+1](cells/sec):
CellDelayVariation[0+1]:
PeakCellRate[0](cells/sec):
CellDelayVariation[0]:
SustainedCellRate(cells/sec):
MaximumBurstSize(cells):
SCRPolicing:
CLPTagEnable:
FrameGCRAEnable:
InitialBurstSize(cells):
LocalRemoteLpbkState:
ChanTestType:
ChanTestState:
ChanRTDresult:
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
17 RowStatus: Add
ChanState: Alarm
YES NO
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
I-AIS/RDI
NO NO
17
Add
Up
VCC
CBR1
PNNI
2
100
100
0
1
1000
CLP hysterisis
1000
900
800
LOW
1000
Enabled
3591
10000 (micro secs)
3591
250000 (micro secs)
10
1024
CLP[0]
Enabled
Disable
0
Disable
No Test
Not In Progress
65535 ms
General AUSM Provisioning Procedures
2-23